To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
Why is my thread loose on the bottom?
Thread tension
Another reason you may experience loose stitches is that the thread tension may be low and may not be tight enough to hold these threads tighter to the fabric. When you experience loose thread, you should readjust your tension to see if it is close enough to stop the loose stitches.
When should you tighten bobbin tension?
If the tension isn’t perfect, fix it by adjusting the bobbin spring; tighter if the bobbin thread shows on the upper layer, and looser if the needle thread shows on the underlayer. Make another test seam, and examine the stitches, repeating until the stitch is balanced.
What causes bobbin thread to bunch up?
Bobbin Thread Tangling
The bobbin keeps pulling and jamming collecting a lot of thread beneath your fabric. There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly.
Why is my sewing machine jamming underneath?
However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.
What number should the tension be on a sewing machine?
As the bobbin thread tension is factory-set and wouldn’t usually be adjusted for normal sewing. So we’ll be talking only about the top thread tension since that’s where you’d usually make the adjustments. The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing.
How do I fix bobbin thread bunching up?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
12.12.2019
What should the tension be on a Brother sewing machine?
The standard tension setting is 4. Start with this, and based on what your test stitching looks like, tighten the tension (below 4) or loosen it (above 4). Typically on Brother machines, to loosen the upper thread tension, turn the dial left. To tighten it, turn the dial right (source).