If the bobbin case doesn’t budge, your bobbin tension is too tight. To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
Why is my bottom stitch looping?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
What number should the tension be on a sewing machine?
As the bobbin thread tension is factory-set and wouldn’t usually be adjusted for normal sewing. So we’ll be talking only about the top thread tension since that’s where you’d usually make the adjustments. The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing.
What should my thread tension be?
Remember, most tension discs close when the presser foot is down, so be sure to thread the machine with a raised foot. A good habit is to put the spool on the machine, and pull out 18 inches of thread.
Why is my sewing machine jamming underneath?
However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.
What causes bobbin thread to bunch up?
Bobbin Thread Tangling
The bobbin keeps pulling and jamming collecting a lot of thread beneath your fabric. There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly.
Why does my thread keep bunching?
What should I do if I experience thread bunching? As “thread bunching” occurs on the underside of the fabric, some people think it is due to the lower thread. They check whether the bobbin is sitting correctly in the bobbin case or even replace the bobbin. … On many models, the upper thread tension is set automatically.
How do I know if my bobbin tension is correct?
The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.
What should the tension be on a Brother sewing machine?
The standard tension setting is 4. Start with this, and based on what your test stitching looks like, tighten the tension (below 4) or loosen it (above 4). Typically on Brother machines, to loosen the upper thread tension, turn the dial left. To tighten it, turn the dial right (source).
What should the tension be set at on a Brother sewing machine?
The tension dial should be set between 2 to 6. b. When the upper thread is just visible on the back of the fabric, the thred tension is correct.
Why is my bottom stitch not catching?
If you are experiencing your bottom thread bunching underneath, it is almost certainly a tension issue if your top tension and bottom tension are different. If your thread is looping underneath, then your top tension is too loose compared to the bobbin tension.